Stand 02/2013 USAToddler / Booster Car Seat Instruction Manual• Certified for use in motor vehicles• Meets or exceeds all applicable requirements of F
9In vans and minivans it is particularly important to ensure that the car seatinstalled in an easily accessible seat in the event that third-party res
10Motorized, automatic vehicle seat belts(Fig. 3.)Lap-and shoulder belts that have aseparate retractors for the lap section andshoulder section (Fig.
Vehicle Lap belts forward of the vehicleseat bight (intersection of the vehicle seatback and vehicle seat cushion) (Fig. 6)4.3 Vehicle lap andshoulder
12For use with Toddler Car Seat- This type of lap and shoulder belt may be used with the Booster Car Seatto secure the child.- Always read and follow
• Slide locking clip onto vehicle seat beltsapproximately 1/2 inch (1 cm) away from latch plate(Fig. 8).• Re-buckle vehicle seat belt.- Check to be su
- If the vehicle seat back angle is variable,adjust the vehicle seat to match the angleof the car seat (car seat contacting seatback) (Fig. 10).5. Tod
NOTE: The seat cushion must always be secured to the car seat using thesnaps on the Seat Cushion StrapsThe seat cushion must be adjusted to fit your c
For children 30 lb (13.6 kg) or less:To adjust seat cushion:- Remove seat cushion by unsnapping seatcushion strap on both sides of car seat andremove
To adjust the headrest height, grasp the headrestheight adjustment handle on the back of theheadrest (Fig. 19; No. 1) and pull it out gently andthen r
Selecting a vehicle seating location with LATCH:The LATCH attachment system (Lower Anchors and Tether for CHildren)provided on this car seat is for in
Car Seat partstop tether beltcar seatprotection shieldbackresttop tether hooksnap fastenerseat cushionLATCHconnectorstorage pocketheadrestshoulder bel
Fasten the hook on the vehicle top tetheranchor by placing the flat spring over thevehicle tether anchor, Press down (Fig. 21;No. 1) and pull back (Fi
Attach the LATCH connector on theopposite side in the same manner.Make sure that the LATCH connector locksin place securely with a audible "click
Secure the child by placing the protectionshield in front of the child with sides of theprotection shield in the protection shieldsslots and slide the
Check that the protection shield is snuggly and properly adjusted (Fig. 27).- Make sure the protection shield buckle is locked in place.- The protecti
5.2.2 Installation using the vehicle's lap and shoulderbelt and top tetherUse top tether whenever possible. Store top tether when not in use.Unbu
Adjust the vehicle seat back into the upright position or the reclineadjustment specified in the vehicle owner’s manual.The back of the car seat must
25Securing your child:Open the protection shield by releasing the Protection shield buckle androtating the protection shield out and to the side of th
26When snuggly adjusted, the vehicle seat belt should not allow any slack. Thevehicle belt should lie in a relatively straight line and be flat, witho
27Recheck the tension of the top tether again and make sure that all slack isremoved. If necessary adjust the belt again (as described above).Periodic
28NOTE: If a tether anchor is not available,store the tether assembly in the storagepocket in back of headrest. See section 7.2for information on how
1. Introduction... 32. Recommended use...
29Tighten the top tether belt to remove all theslack by pulling the free end of the toptether belt toward the car seat (Fig. 40).Securing your child:O
30NOTE: Position the lower LATCH anchor belt so that it doesn't interfere withthe lap belt routing.Snuggly adjust lap belt and protection shield
316. Booster use mode WITHOUT protectionshield from 40 to 110 lb (18 to 50 kg) and upto 57 in (145 cm)6.1 Installation using the vehicle's should
32Center car seat on the vehicle seat betweenseat belt anchorages so that the back of thecar seat contacts the vehicle seat back(Fig. 45).Adjust the v
33Pull the vehicle's lap and shoulder beltforwards. Place shoulder belt behind thehook of the open shoulder belt guide(Fig. 48; Step 3).Close the
34Then pull the vehicle’s lap and shoulder beltout and place under the arm rest on thevehicle seat belt buckle side. Buckle vehicleseat belt listening
35The correct headrest position is achieved when the vehicle's shoulder belt ispositioned at the center of child's shoulder (Fig. 53).To adj
367. Storing LATCH , the assembly of top tetherand removing the protection shield7.1 Storing LATCH connectorsSlide both LATCH connectors and belt adju
377.3 Removal and assembly of protection shield7.3.1 Removing the protection shieldTo remove the protection shield for booster carseat use mode, turn
38From back of car seat, place plastic anchorthrough hole in LATCH lower anchor beltattachment strap an into back of car seat(Fig. 60; No. 1) and secu
3‘kiddy world plus‘ – Operating Manual1. IntroductionWe’re delighted that you have chosen the ‘kiddy world plus’ car seat as yourpreferred car seat.Th
39Open the two flaps at the back of the headrest and pull the back cover outfrom around the yellow height adjustment handle.Free the cover also around
40- Do not use bleach.- Drip dry. Do not spin or place in a tumble dryer.Protection shield cover- The protection shield is surface washable only. Wipe
41This product is warranted against defective materials and workmanship forone year from the date of original purchase. Proof of purchase is required.
4212. Product registrationFOR YOUR CHILD’S CONTINUED SAFETYChild restraints could be recalled for safety reasons. You must register thisrestraint to b
kiddy USA Inc.685 Dividend Dr.Peachtree City, GA 302699Phone: 1-855-92-KIDDYE-mail: [email protected]: www.kiddyusa.comStore the instructionman
Children must meet all of the followingcriteria to use the Toddler car seat WITHthe protection shield:• Age - At least one year of age and• Able to si
53. General safety Warnings• Failure to follow the instructions and labels can result in serious injury ordeath from ejection or contacting the vehicl
6• To prevent ejection or injury in a crash, proper adjustment and useis required.- Check to make sure the car seat is properly adjusted to the size o
7• Vehicle Seat covers made from materials such as velour, leather etc.may show wear marks after using your car seat.• Do not use any accessories or p
4. Vehicle seating position and adjustment4.1 Vehicle seat location requirementsAccording to accident statistics, children 12 and under are safer when
Comentários a estes Manuais